Teen Vent Candelabra
$5.50 Teen Vent Candelabra
Published 2018-09-09T18:12:11+00:00
Hi if you like this check out my other creations and support me here
Like most teens this candelabra is chaotic, going this way and that at the same time, no front or back and definatly no sides, but still with the grace and elagence of its forebears and still, it iluminates a room well with so many tealights in the group.
You can use LED Tealights instead of burning ones for peace of mind - they will fit too.
I have printed this one in Vertigo Grey (Filimentum) my new favourite colour as it compliments the 'Vent' designs.
For FDM printers do not 'hollow out' as it needs the infill to support the base of the candle holders.
As some people have had concerns of melting, I have added a dimple to the holder to ensure the flame is always held off the object (see detail shot) even when the candle is burning out.
- Material PLA
- Layer height 0.1mm
- Nozle width 0.4mm
- Walls 0.8mm
- Top/bottom thickness 1mm
- Infill 12% minimum, cubic
- Print speed 60mm/s
- Wall speed 30mm/s
- Travel 60mm/s
- NO Support needed
- Raft adhesion (Raft makes removal a LOT easier)
- Print time 2d 7h
| Date published | 09/09/2018 |
| Price | $5.50 |
| Tempo per farlo | 3300 - Minuti |
| Quantità di filamento | 334 g |
| Dimensioni | 192mm x 208mm x 224mm |
| Supporto Gratuito | YES |
The candles did not suck. sliced with cura 3.4.1. I used your settings. Flsun cube I printed it with. why did this happen?