Minnie Mouse Bow Holder
Minnie Mouse Bow Holder
Published 2017-07-18T11:19:40+00:00
Printable Minnie Mouse Silhouette to hold bows. Comes in 2 parts that are then glued together.
Print takes roughly 2.5 hours.
Visit my website to see more designs and work I have done. www.adylinn.com
STLs included: bow holder top and bow holder bottom. Files have been repaired and saved in optimal orientation).
Files included: Print and Finishing Info (.txt and PDF) and License (PDF)
Recommended Print Settings:
Filament choice is not important.
Use recommended temperature settings for filament chosen.
Support is optional depending on your overhang performance based on filament chosen.
Infill - 20%
Layer Height - 0.2mm
Orientation - lay flat on back.
Glue together after printing or after finishing.
Date published | 18/07/2017 |
Time to do | 130 - 160 minutes |
Material Quantity | 33g |
Technology | FDM |